Communicate with Supplier? Supplier
Simon Mr. Simon
What can I do for you?
Chat Now Contact Supplier

Foclink Co., Ltd

News

Home > News > The process of manufacturing fiber patch cord

The process of manufacturing fiber patch cord

2017-11-20

Fiber patch cords are widely used for FTTH solution,including SC Patch Cord,LC Patch Cord,FC Patch Cord,ST Patch Cord,multimode & Single Mode Fiber Patch Cord.The production process of fiber optic patch cords is very complicated unless you master it very well. Following is the production process of fiber optic patch cords.

Manufacturing Process of Fiber Optic Patch Cord

Step1: Pretreatment of fiber optic cables. Peel fibers by using technical instrument.

Step2: Installment of Fiber ferrule. Fiber ferrule is an important part of Fiber Optic Patch Cables, so when installing fiber ferrule, the quality of it should be concerned.

Step3: Preparation of grouting glue.Get the glue ready since fiber stub need to be grouted later. Gel injection of fiber ferrule. The standard of a good gel injection is that a little glue can be seen at the front end of fiber ferrule.

Step4: Solidification of colloid. Insert the fiber into fiber ferrule which has been injected gel, and then put it in curing oven to be solidified. Usually, the temperature of solidification is 80 to 90 degree.

As being mentioned, fiber ferrule is a vital part in fiber optic cable, which is used together with the connector that connects the fiber cable either to another cable or to a transmitter or receiver. For further details,kindly contact us via E-mail (simon@foclink.com) and visit our website (www.foclink.com).

Send Inquiry

Simon

Mr. Simon

Tel:86--13879515955

Fax:

Mobile Phone:+8613879515955Contact me with Whatsapp

Email:simon@foclink.com

Address:#3,D of Block,Baolong Industrial Park,Huawang Road,Dalang Street,Longhua District, Shenzhen, Guangdong

Mobile Site